High speed corrugated paper board production line Corrugated board
production line for double wall cardboard Production line for 5 ply
corrugated paper sheet
Products Description
A Complete Corrugating Board Production Line Includes The Following
Machines:Mill Roll Stand, Pre-Heater, Splicer, Single Facer, Over
Bridge, Multi-Pre-Heater, Glue Machine, Double Baker, Slitter
Scorer, Cutoff, Stacker, And Ect.
Raw Paper Roll Feeded to The Roll Stand, After Heated And Moisture
Adjusted By The Per-Heater, Raw Paper Will Go To The Single Facer,
Corrugated By It, And Gluing Together With Another Raw Paper To
Become Single Faced Corrugating Paper, Then Conveyed Through The
Over Bridge, Re-Heated By Multi-Pre-Heater, After Glued By Glue
Machine, Jointed By The Double Backer, Continuous Corrugating Board
Comes Out.
After Slitting And Scorring By Slitter Scorer And Transverse
Cutting By Cutoff, Corrugating Board With Different Sizes Are
Produced. At Last, These Different Sizes Corrugating Board Will Be
Stacked, Calculated.
Heating Way:Steam Heating.
The Photo of Machine
Features
1. Layered independent motor drive, adopts scattered-tooth gear
box, save more than 20% electricity compared with the traditional
gear box
2. To avoid the inconsistent resistance between the upper and lower
belts, to avoid skid on rubber roller of drive wheel, to avoid top
and bottom belt out-of-sync caused by aging canvas belt.
3. For traditional double facer, you have to change the both top
and bottom belts when replacing belt. However, normally the bottom
belt is still in good condition while the top belt worn out. It
will become out-of-sync if just change the top belt without
changing bottom belt. For XHL’s master drive, the layered
independent drive makes it possible to just replace the top belt
4. The top and bottom roller diameter are both Ф910MM and set to
medium-high level, rhombus pattern covered by wearable rubber.
5. Canvas belt guiding roll, our unique design, when the canvas
wear and cause slippery, problem can be solved by adjusting the
guiding roll, to increase the friction between canvas belt and
rubber roll’s wrap angel, take full advantage of the canvas belt’s
service life.
6. Fasting braking, only takes 2 seconds to directly stop when hot
plates speed at 120m/min. This not only reduce the waste rate, but
also saves electricity, production line 150m/min – 300m/min can be
used
Technical Parameters
| 01 | The frame base is welded with 150H steel | 300M / min |
| 02 | pcs hot plates, high-speed canvas belt (produced in Shenyang) | 180mm |
| 03 | The upper / lower roller diameter | Ф910MM |
| 04 | Italy “Phase” Servo motor 30KW / 79KW | |
